Re: JP System 5 Desktop
From:
Marshall Burns (Ennex Corporation)
Date:
Friday, May 19, 1995
From: Marshall Burns (Ennex Corporation)
To: Christian Nelson (DTM Corporation)
Cc: RP-ML
Date: Friday, May 19, 1995
Subject: Re: JP System 5 Desktop
I called Schroff today and asked about the system. It's a
semiautomatic machine that cuts the layers on a knife-plotter and then
uses a manual stacking device to register them to each other. It sounds
similar to a system developed by Sparx in Sweden a few years back and now
discontinued. It is apparently based on some research at the University
of Utah. Schroff is a vendor of a low-cost 3-D CAD program called
SilverScreen.
Best regards,
Marshall Burns
marshall@ennex.com
Ennex Fabrication Technologies
549 Landfair Avenue, Los Angeles, U.S.A. 90024
+1 (310) 824-5185
Previous message
| Next message
Back to 1995 index