RE: Investment Casting of Silicone Rubber

From: Dick Newton - Ford (newton@rrm.org)
Date: Fri Dec 01 1995 - 15:27:51 EET

Next message: Peter H. Gien: "Re: Attn. Pro/Engineer users!! Attn. Pro/Engineer users!!"
Previous message: Andre Dolenc: "EARP contact information wanted"
Maybe in reply to: MR ALBIN A HASTBACKA: "Investment Casting of Silicone Rubber"
Next in thread: GAllen2566@aol.com: "Re: Investment Casting of Silicone Rubber"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

These questions about investment casting of Silicone Rubber bring
up a couple of questions.

Can parts built on a Sanders machine be RTV molded? Do the parts
hold up to the heat produced while the silicone is setting up? Does
the Sanders' wax inhibit the hardening of the silicone? Is the
wax compatible with release agents used in RTV molding?

Dick Newton

Next message: Peter H. Gien: "Re: Attn. Pro/Engineer users!! Attn. Pro/Engineer users!!"
Previous message: Andre Dolenc: "EARP contact information wanted"
Maybe in reply to: MR ALBIN A HASTBACKA: "Investment Casting of Silicone Rubber"
Next in thread: GAllen2566@aol.com: "Re: Investment Casting of Silicone Rubber"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.2 : Wed Jun 20 2001 - 12:57:29 EEST