Re: SLS 350

From: Pierre Bertrand (bertrand@francomedia.qc.ca)
Date: Thu May 30 1996 - 02:27:05 EEST

Next message: Terry Wohlers: "Cast Tooling"
Previous message: Rob Anderson: "Ground Point Searing?"
In reply to: David Leigh: "Re: SLS 350"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

David Leigh wrote:
>
> > Is anyone using the new SLS 350? Is there any feedback on the
> > tolerances obtained?
>
> I believe you mean SLA 350. DTM does not have a new machine, as far
> as I know.
> ----------------------------------------------------------
> David K. Leigh voice (817) 742-1822
> Harvest Technologies fax (817) 742-0053
> Rapid Prototyping Center e-mail harvest@vvm.com
> ----------------------------------------------------------

SLA, not SLS ... sorry for the typo.

Pierre

Next message: Terry Wohlers: "Cast Tooling"
Previous message: Rob Anderson: "Ground Point Searing?"
In reply to: David Leigh: "Re: SLS 350"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:37:22 EEST