IC Shell Mold, Pattern Elimination

From: Gary W. Scholl (gscholl@hitchiner.com)
Date: Mon Sep 23 1996 - 16:21:23 EEST

Next message: axiom@vnet.net: "Re: SLA-350 the good, the bad, and the ugly!"
Previous message: Johannes Eschl: "Re: Part classification"
Next in thread: Yakov Horenstein: "Re: IC Shell Mold, Pattern Elimination"
Maybe reply: Yakov Horenstein: "Re: IC Shell Mold, Pattern Elimination"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Hi,

I have an *opportunity* to cast a QuickCast pattern using IC Shell Mold.
The part is essentially a 10 inch dia x 14 inch tall cylinder with some
*stuff* attached and lots of cutouts. The cylinder walls are .060 inch
thick.

Does anyone have a success story on pattern elimination of such a
geometry? Please provide process suggestions.

tia
g
*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*
Gary W. Scholl v: 1 (603) 673-9720 x 437
Metal Casting Technology, Inc. f: 1 (603) 673-7456
Milford, New Hampshire 03055 e: gscholl@hitchiner.com

Next message: axiom@vnet.net: "Re: SLA-350 the good, the bad, and the ugly!"
Previous message: Johannes Eschl: "Re: Part classification"
Next in thread: Yakov Horenstein: "Re: IC Shell Mold, Pattern Elimination"
Maybe reply: Yakov Horenstein: "Re: IC Shell Mold, Pattern Elimination"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:37:35 EEST