Re: IC Shell Mold, Pattern Elimination

From: Yakov Horenstein (yakov@planet.it)
Date: Mon Sep 23 1996 - 23:38:17 EEST

Next message: Karl Denton: "RP Demos and Utilities CD-ROM"
Previous message: axiom@vnet.net: "Re: SLA-350 the good, the bad, and the ugly!"
Maybe in reply to: Gary W. Scholl: "IC Shell Mold, Pattern Elimination"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

At 9:21 23-09-1996, Gary W. Scholl wrote:

>I have an *opportunity* to cast a QuickCast pattern using IC Shell Mold.
>The part is essentially a 10 inch dia x 14 inch tall cylinder with some
>*stuff* attached and lots of cutouts. The cylinder walls are .060 inch
>thick.
>
>Does anyone have a success story on pattern elimination of such a
>geometry? Please provide process suggestions.

I hope whoever answers you will also make this information public.

-------------------------------------------------------
Yakov Horenstein Tel/Fax: +39 2 2900 6208
Milano, Italy E-mail: yakov@planet.it

Next message: Karl Denton: "RP Demos and Utilities CD-ROM"
Previous message: axiom@vnet.net: "Re: SLA-350 the good, the bad, and the ugly!"
Maybe in reply to: Gary W. Scholl: "IC Shell Mold, Pattern Elimination"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:37:35 EEST