I am sitting here reading about Formus' TSF technology and it says that it
positions the printhead nozzle about .5 inch below the surface of the sand
and sprays a layer of molten wax into the sand. Is this correct? How do
they prevent blockages? How deep is the layer? I suppose they are
building upwards? They can build parts 11ft x 6ft x 4ft in a few hours?
Anybody with experience or useful input?
Elaine
*******************************************************************
Opinions, suggestions, and other controversial matter VOID where prohibited.
******************************************************************
Elaine (Persall) Hunt, Director
Clemson University Laboratory to Advance Industrial Prototyping
206 Fluor Daniel Bldg. Clemson, SC 29643-0925
864-656-0321 (voice) 864-656-4435 (fax)
persall@ces.clemson.edu
http://design.eng.clemson.edu/rp/persall/elaine.html
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:39:28 EEST