Re: CAM from STL

From: Bert VandenBerg (bert@hymarc.com)
Date: Fri May 23 1997 - 23:29:01 EEST

Next message: Steve_Farentinos: "Re: CAM from STL"
Previous message: Bert VandenBerg: "Re: Laser Scanning/digitizing"
In reply to: Terry T. Wohlers: "CAM from STL"
Next in thread: Steve_Farentinos: "Re: CAM from STL"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Terry T. Wohlers wrote:

> DeskProto from Delft Spline Systems (The Netherlands)
>
> DUCT from Delcam (England)
>

Can I add:
Tebis (A german CAM system with an office in Detroit (810-524-0430))

-- 
Bert van den Berg                   E-mail: bert@hymarc.com
Hymarc Ltd.                   http://www.hookup.net/~hymarc
38 Auriga Dr., Unit 5                   Tel: (613) 727-1584
Ottawa, Ontario  K2E 8A5                Fax: (613) 727-0441

Next message: Steve_Farentinos: "Re: CAM from STL"
Previous message: Bert VandenBerg: "Re: Laser Scanning/digitizing"
In reply to: Terry T. Wohlers: "CAM from STL"
Next in thread: Steve_Farentinos: "Re: CAM from STL"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:39:38 EEST