Tim.. Check out Milltronics, Partner Series... It great for aluminum!
P.S. What experience have you with materials suitable as inserts in
SLS RapidTool? Concerned about CTE of aluminum to RapidSteel.
Thinking P-20 better bet. Any thoughts?
How's the family? Getting your life back yet?
Kindest Regards,
Jim Williams
______________________________ Reply Separator _________________________________
Subject: Desktop NC Mills
Author: Tim Gornet <tjgorn01@starbase.spd.louisville.edu> at INTERNET
Date: 5/15/97 1:30 PM
I am sure alot of the RP people out there may also be using some desktop
NC equipment, especially at the university locations. Any leads that
anyone can give to me on some 3 axis NC equipment capable of cutting at
least aluminum would be greatly appreciated.
Tim
-- Tim Gornet Computer Aided Engineering Consultant INTERNET: tjgorn01@starbase.spd.louisville.edu SLUGNET: Vogt Bldg. Rm 101, University of Louisville, Louisville, KY 40292 PHONENET: (502)852-0714 FAXNET: (502)852-8890
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:39:38 EEST