Re: Zephyr Delamination

From: Joseph DeGuglielmo (jfdegug@kodak.com)
Date: Wed Jun 11 1997 - 13:33:13 EEST

Next message: Richard J. O'Neal: "Seeking Casting House 200-500# Grey Iron"
Previous message: Yakov Horenstein: "News about CATIA"
Maybe in reply to: Dark, Jeffrey T: "Zephyr Delamination"
Next in thread: axiom@vnet.net: "Re: Zephyr Delamination"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Jeff,
If you are using z-shifter you will need to extend your supports further
into your part to accomodate the down facing surface shift of the part
layers.

Regards,

Joe DeGuglielmo
Eastman Kodak Company
Rapid Prototyping Center
901 Elmgrove Rd.
Rochester, NY 14653-5315
(716)-726-7046
jfdegug@kodak.com

Next message: Richard J. O'Neal: "Seeking Casting House 200-500# Grey Iron"
Previous message: Yakov Horenstein: "News about CATIA"
Maybe in reply to: Dark, Jeffrey T: "Zephyr Delamination"
Next in thread: axiom@vnet.net: "Re: Zephyr Delamination"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:39:43 EEST