AIMS - failure during part ejection

From: NEIL HOPKINSON (epxnmh@epn1.maneng.nottingham.ac.uk)
Date: Wed Sep 10 1997 - 14:35:16 EEST

Next message: Yakov Horenstein: "It could get worse... (off-topic)"
Previous message: Bart Swaelens: "Part Quotation Software"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Does anyone out there have any information on AIMS mould failure
during part ejection?

The type of information I am after includes:
-release agents, what do you use & why?
-surface finish of moulds, is it vital how smooth do you go?
-time between injection and ejection and reasons for this?
-types of failure encountered, small chips, large blocks, tool wear?
-draft angles, how large, if at all?
-useful references
-anything else you may think is relevant

Many Thanks
Neil Hopkinson

Next message: Yakov Horenstein: "It could get worse... (off-topic)"
Previous message: Bart Swaelens: "Part Quotation Software"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:40:23 EEST