Dear RP'ers
Is there anybody out there in the RP-world who can help me
with som of these questions regarding LOM 2030H, LOM 1015, and
Sinterstation 2000.
Price for the system
Building materials
Tolerances
Service costs per year
Material costs (e.g. per kilo)
Does the equipment need a special room?
How difficult is it to remove the support material?
Compatibility (SGI, Sun, HP....)
Approx. operating costs per year
Layer thickness
Minimum wall thickness
Is the models suitable for snap-functions?
Build time compared to SLA-250
Is there any healt risk working with the materials?
Is the machine fitted for unattended operation?
Where is the nearest distributor located (Norway)?
Is the models suitable for silicone mould patterns?
There are many questions, but I hope some of you have the time
to answer some of them.
Thanks to all for very good response on earlier questions.
Regards,
Roald Karlsen
Norwegian University of Science and Technology
Department of Production and Quality Engineering
7034 Tromdheim
Norway
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:40:37 EEST