Tooling users

From: Marshall Burns (marshall@ennex.com)
Date: Mon Dec 01 1997 - 09:57:52 EET

Next message: Ingrid Timmel: "SIF vs STL"
Previous message: #PHUA KHIANG SONG KENNETH#: "Have these materials been tested on the SLS?"
Next in thread: Brent Stucker: "RE: Tooling users"
Maybe reply: Brent Stucker: "RE: Tooling users"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Dear RP-world,

    I'm interested in learning from people who have experience in using
any of the following tooling techniques:
        -- Keltool (3D Systems)
        -- PHAST (Plynetics Express)
        -- Rapid Dynamics' technique
        -- Brent Stucker's EDM electrodes (Texas A&M University)
        -- Laser Fare's technology (Terry Feeley and Paul Jacobs)
        -- other similar technologies

Would people with this experience either offer comments about them
on the list or contact me privately for discussion?

Thank you.

Best Regards,
Marshall Burns
marshall@ennex.com

*****************************************************************
***** ENNEX(TM) FABRICATION TECHNOLOGIES
***** Fabricating the Future(TM)
*****************************************************************
***** 10911 Weyburn Avenue, Suite 332, Los Angeles, U.S.A. 90024
***** Phone: +1 (310) 824-8700. Fax: +1 (310) 824-5185
***** E-mail: fabbers@ennex.com
***** World Wide Web: http://www.ennex.com
*****************************************************************

Next message: Ingrid Timmel: "SIF vs STL"
Previous message: #PHUA KHIANG SONG KENNETH#: "Have these materials been tested on the SLS?"
Next in thread: Brent Stucker: "RE: Tooling users"
Maybe reply: Brent Stucker: "RE: Tooling users"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:40:48 EEST