Re: Spray Metal

From: Kai Uwe Koch (kuk@IPA.FhG.de)
Date: Mon Jan 12 1998 - 08:55:59 EET

Next message: Marshall Burns: "Re: Selective Laser Sintering"
Previous message: Francois Giasson: "Sand Casting using DTM SandForm"
In reply to: Mike Mao: "Spray Metal"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

On Sun, 11 Jan 1998, Mike Mao wrote:

> I have heard some thing new about rapid tooling from Germany.
> Their way is guite similar to spray metal from the States.
> Does anyone know this German company?

Hello Mike

Maybe you mean
HEK-GmbH
Kaninchenborn 24-28
D-23560 Luebeck
Germany
Tel.: +49(0)451/53004-0
Fax: +49(0)451/53004-50

Regards

Kai

>
> How good it is to do rapid tooling with spray metal?
>
>
> Thanks
> Mike Mao
>
>
>

________________________________________________________________________
Kai Uwe Koch E-Mail: kuk@ipa.fhg.de
Internet: http://www.ipa.fhg.de/
Fraunhofer-Institut
Produktionstechnik und Automatisierung
Nobelstrasse 12
D-70569 Stuttgart Phone: +49 711 970 1856
Germany Fax: +49 711 970 1004
________________________________________________________________________

Next message: Marshall Burns: "Re: Selective Laser Sintering"
Previous message: Francois Giasson: "Sand Casting using DTM SandForm"
In reply to: Mike Mao: "Spray Metal"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:44:42 EEST