Gear Design

From: Robert B. Zajeski (rbz@zetaeng.com)
Date: Tue Jan 27 1998 - 05:31:23 EET

Next message: DAN DAVIS, RAPID PROTOTYPE: "RE: Maestro on IRIX 6.2 vs. 5.3"
Previous message: Steve Stewart: "Maestro on IRIX 6.2 vs. 5.3"
Next in thread: Dorjano.Baruca@src-comp.si: "Re: Gear Design"
Maybe reply: Dorjano.Baruca@src-comp.si: "Re: Gear Design"
Maybe reply: kevan_jones@cemcom.com: "Re: Gear Design"
Maybe reply: Dorjano.Baruca@src-comp.si: "Re: Gear Design"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Hello all,

Does anybody know of any programs that will generate a 3D bevel
gear? Could be 3D wireframe.....or any solid modeler? Thanks in
advance!

Bob Zajeski
rbz@zetaeng.com
ZETA Engineering Company
13338 West Oak Court
Lockport, IL 60441-5974
708-301-3766
708-301-3791 FAX
http://www.zetaeng.com

Next message: DAN DAVIS, RAPID PROTOTYPE: "RE: Maestro on IRIX 6.2 vs. 5.3"
Previous message: Steve Stewart: "Maestro on IRIX 6.2 vs. 5.3"
Next in thread: Dorjano.Baruca@src-comp.si: "Re: Gear Design"
Maybe reply: Dorjano.Baruca@src-comp.si: "Re: Gear Design"
Maybe reply: kevan_jones@cemcom.com: "Re: Gear Design"
Maybe reply: Dorjano.Baruca@src-comp.si: "Re: Gear Design"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:44:46 EEST