AW: Short run tooling again

From: Jürgen Bauer (Juergen.Bauer@spy.siemens.de)
Date: Thu Feb 05 1998 - 14:36:57 EET


Very interesting !!!

Who knows more ?

Regards, Juergen Bauer
Juergen.Bauer@spy.siemns.de
-----Ursprüngliche Nachricht-----
Von: Masuo Namme [SMTP:namme-m@ma.kcom.ne.jp]
Gesendet am: Dienstag, 3. Februar 1998 21:39
An: Ian Gibson; rp-ml@bart.lpt.fi
Betreff: RE: Short run tooling again

Thanks to all the leads on short run tooling, extremely helpful, keep them
coming.

Dear Ian,

I think Teijin Seiki is one of the 1st comer who introduce this technology.
Their technology is supported by their own developing high heat resistance
resin.
As far as I know this material is best for tooling application as this can
stand up to 250 degrees Celsius.

           =====================================
                            Masuo Namme
                       Director Marketing
                      Shonan Design CoLtd
            TEL:81-427-75-0448 FAX:1-427-71-9744
           ====================================

For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/

For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/



This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:44:50 EEST