Mike,
You may want to visit your local photo shop and ask for "Black Room Cloth"
Hope this helps
Carl Dekker
metlflo@mw.sisna.com
Miller, Michael W wrote:
> We are getting surface skinning (cured resin) in the right front corner
> of our SLA500 near where the laser parks between layers. Our 3d
> maintenance person believes it is caused by laser reflection off all the
> resin spills on the cover plate. It has been suggested we dip the cover
> into hot water to soften and then remove the spilled resin. An
> alternate solution might be to paint? or apply some material in the area
> that would absorb rather than reflect the UV. Any suggestions as to
> what cheap and readily available material effectively absorbs UV?
> Thanks,
> Michael W Miller (Mike.Miller3@PSS.Boeing.com)
> The Boeing Company MS 17-PE B-XT62
> Propulsion Experimental Hardware 206-655-3289
> Rapid Prototyping 655-4366 Lab 655-4365
>
> For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:44:55 EEST