Dear RP community,
I am looking for some company who has experience in molding, either
from silicone or from a rapid tool foam material to make a light weight
part with a density of about 0.2 - 0.3 g/cm3, starting from either an
SLA pattern we could deliver or an STL file if in house SLA capabilities
are available. The part in question is a particularly shaped tyre
protecting a wheel with a diameter of about 270 mm. The part should
exhibit a Shore hardness of about A 40 and the material should have a
white or translucent base color so that a pigment with the appropriate
color (probably) could be added. We would need about 20 copies.
Thanks in advance for any suggestions or comments
Paul Bernhard
-- ********************************************************************** PROFORM AG Rapid Prototyping and Stereolithography Route de Fribourg 42 CH-1723 Marly 2, Switzerland Tel. +41 (026)-436 43 83 E-mail: proform@proform.ch Fax. +41 (026)-436 43 29 WWW: http://www.proform.ch **********************************************************************For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:45:16 EEST