software Q

From: Rajeev Garg (rgarg@sut1661.Princeton.EDU)
Date: Fri May 15 1998 - 17:53:45 EEST

Next message: VERN CARTER: "Re: experience with Z402"
Previous message: Kiril Sotirov: "Soft/Hard Tooling"
In reply to: Kiril Sotirov: "Soft/Hard Tooling"
Next in thread: Michael Tsenter: "Re: software Q"
Reply: Michael Tsenter: "Re: software Q"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

I am looking for a software to cut the STL files into two or three
pieces. Is there a demo copy of any easy to use software on the web that
will do such a job.

I know this info has been on the list before, but I don't remember.

Thanx for the help

Rajeev Garg

For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/

Next message: VERN CARTER: "Re: experience with Z402"
Previous message: Kiril Sotirov: "Soft/Hard Tooling"
In reply to: Kiril Sotirov: "Soft/Hard Tooling"
Next in thread: Michael Tsenter: "Re: software Q"
Reply: Michael Tsenter: "Re: software Q"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:45:38 EEST