Quickslice 5.0 on Digital Alphastation 500

From: Victor.Kronestedt@ecs.ericsson.se
Date: Wed May 27 1998 - 12:14:05 EEST

Next message: bvanhiel@nordson.com: "Free speech my...apologies."
Previous message: charriere eric: "Benchmark for 3D-Printers"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Has anyone successfully installed Quickslice 5.0 for Windows NT 4.0 on a
Digital Alpha 500 workstation?

I`ve tried to install Qs 5.0 on my ALPHA 500 by using Digital FX!32. The
installation seems OK, but Quickslice
fails when I open a STL-fil. According to Stratasys, Quickslice runs
only on Intel processors. But since I`m using several
programs like MS Office97 on my computer today, which are written for
Intel processor, it should work.

> Victor Kronestedt
> Ericsson Mobile Communications AB
> Torshamnsgatan 39, Kista
> S-164 80 Stockholm
> Sweden
>

For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/

Next message: bvanhiel@nordson.com: "Free speech my...apologies."
Previous message: charriere eric: "Benchmark for 3D-Printers"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:45:43 EEST