Re: A question about Injection Moulding

From: bvanhiel@nordson.com
Date: Wed Jun 03 1998 - 16:13:09 EEST


Neil,

Unless someone else has taken over my project, I am (was) the student
working on ejection from SLA molds. I was unable to get more than
preliminary results (not all of the designs could be manufactured in time),
but there was some promise in the pneumatic pistons. An un-updated web
page exists which spells out the project goals is at:

http://rpmi.marc.gatech.edu/~vanhielb/embedded_ejection/embedded_mainpage.ht
ml

While the Results and Conclusions are not posted, the references are there.

Good Luck,

Brian

*** Brian VanHiel - Mech. Eng. - Nordson Corp - bvanhiel@nordson.com ***

For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/



This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:45:49 EEST