Re: Investment Casting

• Next message: Drew Brown: "SLA250 laser power"
• Previous message: Marshall Burns: "Re: Investment Casting"
• In reply to: Marshall Burns: "Re: Investment Casting"
• Next in thread: Tien-min Gabriel Chu: "Re: Investment Casting"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Hi Marshall / All,

When I say small, I not only mean small size but also smaller production
volumes, typically 1 to 5 or 10 per part.

> intend to do investment casting at Ennex, but I am interested in what
> might
> be meant by a "small" investment casting facility. Foundries I have
> seen
> are all big, dirty, factories. Is there a more office-friendly way to
> do
> investment casting if your patterns are small?
>
> --
> Marshall Burns
> Marshall@Ennex.com
>
> *****************************************************************
> ***** ENNEX(TM) CORPORATION
> ***** Fabbing the Future(TM)
> *****************************************************************
> ***** 10911 Weyburn Avenue, Suite 332, Los Angeles, U.S.A. 90024
> ***** Phone: +1 (310) 824-8700. Fax: +1 (310) 824-5185
> ***** E-mail: Fabbers@Ennex.com. Web site: http://www.Ennex.com
> *****************************************************************

--
With Best Regards from Shreyas J Bakshi
http://www.protosystech.com
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/

• Next message: Drew Brown: "SLA250 laser power"
• Previous message: Marshall Burns: "Re: Investment Casting"
• In reply to: Marshall Burns: "Re: Investment Casting"
• Next in thread: Tien-min Gabriel Chu: "Re: Investment Casting"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:45:58 EEST