IGES to STL

From: Shreyas J Bakshi (sjbakshi@protosystech.com)
Date: Wed Jul 01 1998 - 16:39:27 EEST


Hi all,

Can some users share their experience on the aspects of using some IGES
to STL software versus using a CAD software to do the same. I understand
that using a CAD software will involve first doing the IGES-IN then
either stitching/patching/offseting the surfaces into a solid and then
generating the STL-OUT. But what I would like to know from the users' is
how good each of these methods have been for them

Thanks in advance.

--
With Best Regards from Shreyas J Bakshi
http://www.protosystech.com

For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/



This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:46:06 EEST