Henri Koukka wrote:
> Hey come on, my friends. I'm sure you can do it better... In my opinion the
> list of methods died too quickly. Maybe we should start it again. If I
Henri,
You could add Ennex Corporation, developing the fabricator to be called the
Genie Studio Fabber, using the process known as Offset Fabrication. Web
address: http://www.Ennex.com/.
Best regards,
Marshall Burns
Marshall@Ennex.com
*****************************************************************
***** ENNEX(TM) CORPORATION
***** Fabbing the Future(TM)
*****************************************************************
***** 10911 Weyburn Avenue, Suite 332, Los Angeles, U.S.A. 90024
***** Phone: +1 (310) 824-8700. Fax: +1 (310) 824-5185
***** E-mail: fabbers@Ennex.com. Web site: http://www.Ennex.com
*****************************************************************
***** Copyright (c) 1998, Ennex Corporation
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:46:08 EEST