Re: RP for manufacturing

From: Nathaniel J. Leon (connectcds@home.com)
Date: Mon Jul 13 1998 - 18:33:38 EEST

Next message: Ricky Low: "Fw: Light machines-Attn. Neil Leon"
Previous message: Robert Holmes: "Re: RP for manufacturing"
In reply to: Richardson, Curtis A: "RP for manufacturing"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Richard:

What are you looking to do?

What sort of conversion processes are you looking to perform on the 12"
x 18" x .030" thick aluminum plated?

With only .030 thickness there is not much to do except punching holes
and rolling the surface to form complexed curves.

Niel Leon - CDS,inc

For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/

Next message: Ricky Low: "Fw: Light machines-Attn. Neil Leon"
Previous message: Robert Holmes: "Re: RP for manufacturing"
In reply to: Richardson, Curtis A: "RP for manufacturing"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:46:13 EEST