Mass and part geometry are separate. If the part has a consistant .125
wall thickness then test the exotherm of .125 deep paper cup of mixed
resin. If and only if the mass is spread out evenly with an equal amount of
silicone wall thickness. But wait, if the total part mix is more than 3
ounces only the skill of a human with experience will know what to do. So
much for real useful information.
Mark Schanze
Molding Technologies Manager
CIVCO Medical Instruments
319 656 4447
marks@civcomedical.com
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:46:22 EEST