In a message dated 8/12/98 4:51:35 PM Eastern Daylight Time,
pgersbeck@expresstool.com writes:
<< The new technology, introduced in the fall of 1997, can reduce the molding
cycle time of products by 20-30 percent by allowing the use of high
productivity production inserts for molds. A key to the reduction in cycle
time is the use of conformal cooling, which removes heat from molds more
efficiently and uniformly than conventional methods. >>
Conformal cooling? Any ideas of what this entails?
Roy Sheppard Jr.
Atlantic Technical Components
269 Heather Lane
Franklin Lakes, NJ 07417
(201) 337-2477 FAX (201) 337-3008 Email royjratc@aol.com
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:46:29 EEST