Dear Pedro,
Digibotics has two contract service facilities that scan parts to create STL
files regularly. This service is offered out of both Austin, Texas and
Detroit, Michigan and specializes in 3D Digitizing for reversed engineering,
Part Verification, and FEA/CFD Analysis. Please feel free to contact Todd
Woiwode in the Austin office at (512) 832-9040, or at Todd@digibotics.com.
Or you may contact Russ Beck in the Detroit office at (248) 374-1900, or at
Russ@digibotics.com to obtain a quote or discuss any questions or concerns.
Regards,
Eric Koch
Digibotics, Inc.
2800 Longhorn Blvd., Ste. 104
Austin, TX 78758
Ph: (512) 832-6544
Fax: (512) 832-1163
E-mail: eric@digibotics.com
www.digibotics.com
-----Original Message-----
From: owner-rp-ml@bart.lpt.fi [mailto:owner-rp-ml@bart.lpt.fi] On Behalf Of
PEDRO SANTOS
Sent: Monday, September 14, 1998 12:52 PM
To: rp-ml@bart.lpt.fi
Subject:
This note should read as follows. Sorry about the typos on the original,
Mondays....
I'm looking for a service bureau that can take an SLA model and reverse it
back
to an .stl file. Any suggestions? Also, can anyone recommend a good method
to
measure accuracies on SLA models?
---------------------- Forwarded by Pedro Santos/NA/GDYR on 09/14/98 01:50
PM
---------------------------
Pedro Santos
09/14/98 12:33:27 PM
To: rp-ml@ltk.hut.fi@internet
cc:
Subject:
I'm looking for a service pure that can take an SLA model and reverse it
back
to an .stl file. Any suggestions? Also, can anyone recommend to measure
accuracies on SLA models?
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:46:42 EEST