William D. Richards [wdr@virtcon.com] sent an example of a nut and bolt
.stl
this is a good example of a bad stl
no units ( I assume it is 2.953 inches long but then if it was for a
watch it could be 2.953 mm )
the nut does not have a hole through it and both are quite coarse.
There would be difficulty in turning the nut onto the bolt because of
the concave/convex chordal deviation interference's
does FormZ output a STEP or IGES file.
Jan Andrzejewski
RP Operations Manager
jan.rp@pera.com
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:46:46 EEST