CIBA polymers 'Parts in Minutes' 5215 A/B (PU for low pressure resin
injection machines) normally withstands 130-140C when post-cured , so
it should withstand short peaks of 150C.
Trevor Howarth
Project Engineer
Rover Group Rapid Prototyping & Tooling
3rd floor, ATC
University of Warwick
Tel. 01203 524788
Fax. 01203 524878
e-mail: trevor.howarth@rover.co.uk
-----Original Message-----
From: koukka
Sent: Tuesday, October 20, 1998 1:09 PM
To: rp-ml
Cc: koukka
Subject: Heavy-duty polyurethanes
Dear All!
I was wondering if someone would know if there is polyurethane which is
able to withstand temperatures between 100 - 150 C (210 - 300 F). In my
application temperature is normally near 100 C but sometimes it peaks
up to
150.
Cheers
Henri
-------------------------------------------------------------------
Henri Koukka
Researcher Tel: +358-3-5250 214
Helsinki University of Techn. Mobile: +358-40-5848 579
Lahti Centre Fax: +358-3-5250 204
Saimaankatu 11 Email: koukka@ltk.hut.fi
FIN - 15140 LAHTI
FINLAND
-------------------------------------------------------------------
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:46:57 EEST