List members:
I am teaching a course in RP at Arizona State University and using the text
by Chua and Leong , but am trying to find a book that is more technical. I
have located a good book by Jerome L. Johnson entitled "Principles of
computer automated fabrication" published by Palatino Press in Irvine, CA,
but it is a little old, out of print and I can't locate either the author or
publisher.
Can any of you suggest a text which would be good for graduate engineering
students to give an overview of RP/RF? The SFF book by Beaman is $137.50
which is too expensive and the Jacobs book on SLA, etc., is too SLA-focused.
I liked the Johnson book mentioned above but even if I can locate copies, it
was published in 1994 which is ancient history in RP/RF. I do use the web
extensively in the course, so the students can find the information from the
Chua and Leong text at specific internet company sites.
Any comments, suggestions are appreciated.
Mark Henderson
Professor of Industrial Engineering
Arizona State University
Tempe, AZ 85287-5906
(602) 965-2899
FAX: (602) 965-8692
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:47:18 EEST