Spray Metal Tooling

From: Erik Murphy (emurphy@harringtonpdc.com)
Date: Fri Nov 20 1998 - 16:25:44 EET

Next message: Steve Stewart: "Re: SLA - Part Building Issue"
Previous message: Seppo J Niemi: "Re: Procedure request"
Next in thread: joel.segal@roverpte.demon.co.uk: "RE: Spray Metal Tooling"
Maybe reply: joel.segal@roverpte.demon.co.uk: "RE: Spray Metal Tooling"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Hello All,

I would like to know if anyone has had problems using SL patterns built
with Ciba 5170 resin.

We recently built a spray metal tool using a pattern from this resin. We
experienced some warping while applying the spray metal. We think that the
resin is possibly out-gassing.

Any comments or suggestions would be appreciated.
Erik Murphy

Harrington Product Development Center

"Bringing it all Together"
Your partners in product development solutions

Phone:(513)482-4700
Fax: (513)482-4706

mailto:emurphy@harringtonpdc.com
Home Page: http://www.harringtonpdc.com

For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/

Next message: Steve Stewart: "Re: SLA - Part Building Issue"
Previous message: Seppo J Niemi: "Re: Procedure request"
Next in thread: joel.segal@roverpte.demon.co.uk: "RE: Spray Metal Tooling"
Maybe reply: joel.segal@roverpte.demon.co.uk: "RE: Spray Metal Tooling"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:47:20 EEST