One other note on .STL creation from Pro/E: if the settings for chord-height
and angle control do not give you a desirable tesselation, increasing the part
accuracy by lowering the part-accuracy value setting under setup will give
much finer triangulation. Also, angle control is still buggy after 10 or so
revisions, so for high quality on large parts with fine details set it to 0 or
off for better results.
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:47:23 EEST