Thanks your feed back!
Bo Yang, Ph.D Candidate
Dept. of Mechanical Engineering
NJIT, Newark, NJ 07102
Phone:973-642-4577
fax: 973-596-5601
http://megahertz.njit.edu/~bxy0487
On Sun, 29 Nov 1998, Monica & Glenn Whiteside wrote:
> Bo Yang, you wrote:
>
> >Dear RP Friends:
> >
> >As many of you requested, I put some of my research results on Rapid
> >Tooling and Manufacturing on the webpage:
> >http://www-ec.njit.edu/riml/proj/RPT/rpt1.html. You can also go to
> >http://www-ec.njit.edu/riml/index.html to check out other RP projects
> >being investigated in our lab.
> >
> >Much work on RP&M has been done in this lab and it is time to make these
> >projects to fly. So feel free to contact Dr. Leu, Lab Director at
> >mleu@nsf.gov or bxy0487@oak.njit.edu to discuss cooperation opportunity.
> >
> >Bo Yang, Ph.D Candidate
> >Dept. of Mechanical Engineering
> >NJIT, Newark, NJ 07102
> >Phone:973-642-4577
> >fax: 973-596-5601
> >http://www-ec.njit.edu/riml/students/by/index.html
> ****************************************************************************
> *
> Bo Yang:
>
> Nice informative websites. The article on electroplating/electroforming
> dies, molds, and EDM tooling was interesting. I especially found
> interesting the article on "Rapid Freezing Prototyping" (RFP) where a 3D ice
> part is built by depositing and rapidly freezing water in a layer-by-layer
> manner. You can't get a more environmentally friendly material than water,
> just place it out in the hot sun and it's recycled in a matter of minutes.
> This could have some applications for duplicating icing formations for
> aircraft icing tests......anybody looked at this yet?
>
> Regards,
>
> Glenn Whiteside
> e-mail: siderwhite@worldnet.att.net
>
>
>
>
>
>
>
> For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
>
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:47:27 EEST