Dear Chang-Shik,Min;
The quality of surface finnish of RP parts is basically limited by the
thickness of
the layers used in building them. I would suggest that you consider a
Sanders
machine because it is capable of producing a very small layer thickness.
http://www.sanders-prototype.com/main.html
Still this would NOT give you a "polished" surface, i.e.: better than 32
RMS.
Best Regards
-- Greg Pettengill greg_p@indirect.com Phone (602)846-8410 http://www.indirect.com/www/greg_p/index.htmlFor more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:47:48 EEST