Rapid Tooling and Rapid Prototyping

From: Christina Fuges (Christina@MOLDTECHNOLOGY.COM)
Date: Tue Feb 02 1999 - 19:54:09 EET

Next message: Hodder, David J: "RE: Ambiguous Terminology"
Previous message: tom@paramountind.com: "Re[3]: Ambiguous Measurement Terminology, slightly off topic"
Next in thread: Tom Richards: "Re: Rapid Tooling and Rapid Prototyping"
Maybe reply: Tom Richards: "Re: Rapid Tooling and Rapid Prototyping"
Maybe reply: Christian_Nelson/DTM@dtm-corp.com: "Re: Rapid Tooling and Rapid Prototyping"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

What is the difference between rapid tooling and rapid prototyping. The
two terms are almost always mentioned together, but the more I read into
it the two are actually very different.
Are the same processes used for different purposes or does each have its
own processes? Please advise.

Christina
CTI
christina@moldtechnology.com

For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/

Next message: Hodder, David J: "RE: Ambiguous Terminology"
Previous message: tom@paramountind.com: "Re[3]: Ambiguous Measurement Terminology, slightly off topic"
Next in thread: Tom Richards: "Re: Rapid Tooling and Rapid Prototyping"
Maybe reply: Tom Richards: "Re: Rapid Tooling and Rapid Prototyping"
Maybe reply: Christian_Nelson/DTM@dtm-corp.com: "Re: Rapid Tooling and Rapid Prototyping"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:50:53 EEST