>
>anyway) in a couple of years. The Clemson site has the file listed, but
>it is no good. The file is very old, so I doubt the the CAD information
>is known.
>
When you unzip the user part on our site .....it's name is user.acs or
something.
Just rename it user.stl and then you can use it. It is an ASCII file of
the original user part. This part was most likely modeled on ARIES. I
will try to see if I can locate Ed's original plans or work sheet detailing
just how the models were to be made. There were specific directions as to
how to make the parts. The reason for this was to eliminate user 'noise'
and be able to get machine accuracy NOT user/machine accuracy.
Elaine
*******************************************************************
Opinions, suggestions, and other controversial matter VOID where prohibited.
******************************************************************
Elaine T. Hunt, Director
Clemson University Laboratory to Advance Industrial Prototyping
206 Fluor Daniel Bldg. Clemson, SC 29643-0925
864-656-0321 (voice) 864-656-4435 (fax)
elaine.hunt@ces.clemson.edu
http://rafiki.vr.clemson.edu/credo/persall/persall.html
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:51:01 EEST