Ever have one of those days????!!!!!!!!! I was thinking of something else
when I read this message and replied to it. The .slc file is NOT a
Stratasys file (an .ssl and .sml are). So
.....................................nevermind!
Wayne
"Wayne L Foss" <wlfoss@crnotes.collins.rockwell.com> on 02/23/99 09:19:21
AM
To: Florent Salako <salako@meca.polymtl.ca>, rp-ml@bart.lpt.fi
cc:
Subject: Re: SLC file ?
An .slc file is the slice file for the Stratasys FDM process. I'm not sure,
but I think it only works in Stratasys Quickslice software. It describes
the part and supports profile at each slice. The toolpath for material
extrusion is described by an .sml file.
Wayne Foss
Rockwell Collins
Cedar Rapids, Iowa
Florent Salako <salako@meca.polymtl.ca> on 02/18/99 01:10:34 PM
To: rp-ml@bart.lpt.fi
cc:
Subject: SLC file ?
Does anyone know what a slc file is (in RP) ?
Can I get a file example ?
Thanks.
Florent.
_________________________________________
Florent Salako
Prototech Centre
Tel: (514) 340-3245-6
Fax: (514) 340-3246
salako@meca.polymtl.ca
http://www.prototech.polymtl.ca/
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:51:02 EEST