Ummmmm Brad? How about the temperature requirement of 125 degrees C? 3D
must be sending you much better Actua material than they are sending me!
;-)
Chad
> -----Original Message-----
> From: owner-rp-ml@ltk.hut.fi [mailto:owner-rp-ml@ltk.hut.fi]On Behalf Of
> Brad Fox
> Sent: Tuesday, March 02, 1999 10:07 AM
> To: Wayne L Foss
> Cc: rp-ml@bart.lpt.fi
> Subject: Re: Very small details
>
>
> Wayne:
> Sounds like this would be a good part for either the small dia. beam SLA -
> or the Actua. If you've ever seen the "business card" sample out of the
> Actua, it would leave little doubt that the Actua could do the part.
>
> Attach the file to me Wayne, and I'll build the part for you.
>
> Regards,
>
> Brad Fox
> Rapid Design Technologies
>
>
>
> At 04:18 PM 3/1/99 -0600, you wrote:
> >
> >
> >I have a potential need for a source that can produce small, highly
> >detailed parts to the specifications that follow. The part will
> be used for
> >isolating and mounting IC chips in a test fixture. Dimensions are in
> >inches.
> >
> >The part will have .007 thick fins that are .100 high and .050 wide. They
> >may be attached to a solid structure at one end (along the .100)
> and/or the
> >bottom (along the .050). There is a space between fins of .010
> which makes
> >the pitch .017. This part will fit over (or under) the IC and
> the fins will
> >fit in between the "waterfall" of the leads. There are 60 leads per side
> >for a total of 240. The material must be strong, withstand a
> temperature of
> >125 degrees C and must be electrically non-conductive.
> >
> >I do not have drawings yet. We will consider any process.
> >
> >I do know of Pure Fluid Magic, but Ms. Iverson, in my last conversation
> >with her, indicated that she was not taking on any outside projects.
> >
> >Thanks in advance for your help.
> >
> >
> >Wayne Foss
> >Rockwell Collins, Inc.
> >Cedar Rapids, Iowa.
> >
> >
> >
> >For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
> >
> >
>
>
> For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
>
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:51:07 EEST