RE: C-Mold Quickfill

From: DANIEL CHARLES DAVIS (DANIEL@proton.com.my)
Date: Wed Apr 21 1999 - 12:34:38 EEST

Next message: Pressley, Rick: "Fred Steinbauer"
Previous message: DANIEL CHARLES DAVIS: "C-Mold"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Martin,

That is what I am wondering. More specifically C-Mold 3D Quickfill, as
we are not really interested in heavy-duty CAE, just some help for some
employees of mine who are not moldmakers.

What I am looking for is some "generic" castable polyurethane that has
been tested for the following: melt-mass flow rate in grams/10minutes at
n Centigrade (probably room temp) and under n Kg load (probably
atmospheric pressure). These are the inputs required.

I think that the data output would be good enough to assist in the
design of complex silicone and/or epoxy tools.

---
Regards,
Dan Davis
PROTON Rapid Prototyping & Manufacturing Center
Hicom Industrial Estate, Batu Tiga, PO Box 7100
Shah Alam, 40918 Selangor MALAYSIA
+60 3 515-2380 phone/fax
http://www.protoncar.com/rapid/index.htm
> -----Original Message-----
> From:	Martin CM Wong (IC) [SMTP:icmwong@inet.polyu.edu.hk]
> Sent:	Wednesday, April 21, 1999 5:12 PM
> To:	DANIEL@proton.com.my
> Subject:	Re: C-Mold
> 
> Dear Dan,
> 
> We are using C-mold, RIM and PU Casting, I wonder whether the viscous
> elastic flow pattern of pressure injection moulding simulation package
> could do the job for RIM and PU casting.
> 
> Regards,
> 
> Martin Wong
> Industrial Centre
> The Hong Kong Polytechnic University
> Tel.: (852) 2766 7625
> Fax : (852) 2334 4634
> E-mail: icmwong@polyu.edu.hk
> 
> >>> DANIEL CHARLES DAVIS <DANIEL@proton.com.my> 04/21 3:59 PM >>>
> Hello all,
> 
> Is anyone out there using C-mold with RIM or castable urethanes?  If
> so,
> can you share some generic information regarding the custom resin
> specification needed for setting up the C-Mold program?  TQ.
> 
> ---
> Regards,
> Dan Davis
> PROTON Rapid Prototyping & Manufacturing Center
> Hicom Industrial Estate, Batu Tiga, PO Box 7100
> Shah Alam, 40918 Selangor MALAYSIA
> +60 3 515-2380 phone/fax
> http://www.protoncar.com/rapid/index.htm 
> 
> 
> 
> For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/

Next message: Pressley, Rick: "Fred Steinbauer"
Previous message: DANIEL CHARLES DAVIS: "C-Mold"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:51:31 EEST