Re: NEW Message: Part 2 of Converting *.dxf to *.stl

• Next message: Jack Feng: "new virus "How to Give a Cat a Colonic,""
• Previous message: Priit Kull: "Re: Confused"
• In reply to: Bharath Vasudeva Rao: "Re: NEW Message: Part 2 of Converting *.dxf to *.stl"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Mitchell

I have Bentley Microstation which found very good to read several formats DXF,DWG,PRT,... etc and is good as well in creating clean STL files.
I will be please to try converting yours, just send your file as an attachment.

best regards

*********************************************************************
** Rafael Santillan, Ph.D. Mech. Eng. Office Phone: 52-42-112623 **
** Analysis and Numerical Simulation Fax: 52-42-169963 **
** Proc. Energ. **
** **
** CIATEQ Centro de Tecnología Avanzada **
** <http://ciateq.mx/> **
** **
** Address: Calzada Retablo 150 Email: santillan@ciateq.mx **
** Queretaro,Qro. / MEXICO ZIP 76150 **
*********************************************************************

For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/

• Next message: Jack Feng: "new virus "How to Give a Cat a Colonic,""
• Previous message: Priit Kull: "Re: Confused"
• In reply to: Bharath Vasudeva Rao: "Re: NEW Message: Part 2 of Converting *.dxf to *.stl"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:51:37 EEST