The material of construction of patterns built by the Sanders RP machines is
fully compatable with our investment casting processes.
At 02:00 PM 6/3/99 +0800, you wrote:
>Hi Tom,
>
>This is Jimmy Yip writing from Singapore. We have met during the SME 99
>conference. I was hoping if you could help by providing me some
>information regarding investment casting using part generated from Sanders
>MM II. In our conversation you mention that you've casted parts from the
>MMPRO6 machine. When I check my material data sheet on the Proto-Base, I
>realised that there are contents of Chloride and Flourine. I don't think
>these material are suitable to be burnt off, are they?
>
>Your Feed back is greatly appreciated.
>
>Thank you for your kind attention.
>
>Regards,
>Jimmy Yip
>Gintic Institute of Manufacturing Technology
>Development Division / Rapid Tooling Development Centre
>71 Nanyang Drive, Singapore 638075
>E-mail: csyip@gintic.gov.sg
>Fax: (65) 7925362
>Tel: (65) 7938518/7938960
>
>
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:51:49 EEST