In a message dated 99-06-04 16:40:31 EDT, HLuper@SOLIDIFORM.com writes:
<< With NT 4.0 WORKSTATION, 3DLightyear only used one of the
processors and basically "pegged" it out while the other was barely used. >>
Is that due to poor software design on the part of 3DLightyear? In my
experience ProEngineer, a much much more computational intensive software,
runs just fine on even a single processor.
Andy Scott
Lockheed Martin Aero Systems
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:51:50 EEST