stl tolerences

From: V Lotke (V.Lotke@m.cc.utah.edu)
Date: Mon Jun 28 1999 - 09:16:12 EEST


Hi list,

I understand that when the facets are dumped in a stl file, many a times
it happens that the same point may be printed out as very close though
with different coordinates ( in different facets ). If there are any
guidelines about these tolerences in different systems,within which limits
we consider two points to be same, I'd be grateful to have them.

regards,
Vipul

-------------------------------------------------------------------------
Vipul Lotke -| 1155 E 500 S, | Phone nos.
Grad. Student,(MS) -| Apt. # 15, | 583 6904 ( res )
Mechanical Engg. Dept,Room 3208 -| Salt Lake City, | 585 9752 ( off )
Univ. of Utah -| Utah. |

For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/



This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:51:59 EEST