Seeking EDM and water-jet sources

• Next message: ETP rapid prototype: "information"
• Previous message: Leading Edge Marketing Services: "Direct Sintering of Metals and Site requirements."
• Next in thread: Wolfram Oldörp: "Re: Seeking EDM and water-jet sources"
• Reply: Wolfram Oldörp: "Re: Seeking EDM and water-jet sources"
• Maybe reply: Donald Rothwell: "Re: Seeking EDM and water-jet sources"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Dear RPers,

    We are preparing a request for quote to go out to a number of
fabrication sources that can do thin-walled structures. We would like to
also submit the RfQ to a couple of sources that do EDM or water-jet cutting.
Do any of you have recommendations of good sources for these services?

    Thank you for your assistance.

Best regards,
Marshall Burns

Marshall@Ennex.com
Ennex Corporation, Los Angeles, USA, (310) 824-8700
www.Ennex.com

For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/

• Next message: ETP rapid prototype: "information"
• Previous message: Leading Edge Marketing Services: "Direct Sintering of Metals and Site requirements."
• Next in thread: Wolfram Oldörp: "Re: Seeking EDM and water-jet sources"
• Reply: Wolfram Oldörp: "Re: Seeking EDM and water-jet sources"
• Maybe reply: Donald Rothwell: "Re: Seeking EDM and water-jet sources"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:52:11 EEST