Dear list,
We are currently using SIBCO Inc. LOMPOXY resin to infiltrate our LOM parts
and make them stronger and more heat resistant.
A customer of ours is interested in using a LOM part as a master pattern for
sand casting.
By impregnating the LOM part with LOMPOXY, how many times can the LOM part
be used as a master pattern? Is it good to be used as a master pattern for
5-10 runs??
I need some answers immediately....can anyone on the list help?
Thank you very much.
Best regards,
Raymond Tan,
Rapid Prototyping and Manufacturing Center,
Research & Development Department,
PROTON BHD.
Shah Alam, Malaysia.
============================================================
Disclaimer Note:
"This email and any files transmitted with it are confidential and intended
solely for the use of the individual or entity to whom they are addressed.
This communication may contain material protected by intellectual property
rights laws. If you are not the intended recipient or the person responsible
for delivering the email to the intended recipient, be advised that you have
received this email in error and that any use, dissemination, forwarding,
printing, or copying of this email is strictly prohibited. If you have
received this email in error please notify the System Administrator at
administrator@proton.com.my "
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:52:15 EEST