We machine plastic injection molds and have injected walls of .1mm to a
length of 3mm in HDPE.
Is that "good"?
Paul Finelt
At 07:46 AM 9/24/99 -0400, Elaine Hunt wrote:
>
>Anybody done any better than these guys? What is the thinnest wall section
>or sections you've done?
>
>
> >Recently we have been successful in developing thin wall (down to .005
> >inch) injection molding technology with our rapid tooling. To my knowledge
> >there is no tooling method to mold walls this thin.
> >mail@albright1.com
> >v 978-422-8051 f 978-422-8058
> >92 Albright Road
> >Sterling,MA 01564
>
>*******************************************************************
>Opinions, suggestions, and other controversial matter VOID where prohibited.
>******************************************************************
>Elaine T. Hunt, Director
>Clemson University Laboratory to Advance Industrial Prototyping
>206 Fluor Daniel Bldg. Clemson, SC 29643-0925
>864-656-0321 (voice) 864-656-4435 (fax)
>elaine.hunt@ces.clemson.edu
>http://rafiki.vr.clemson.edu/credo/persall/persall.html
>
>
>
>For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
>
>
>-=-=-
>Spam Be Gone! Won't predict until you have trained on at least 5 messages.
PLF
"The Big Secret is .. there are no secrets."
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:52:51 EEST