Dear list,
As usual, i've got a question to ask regarding Lightyear. The other day, i
hollowed a solid part in Magics RP, with a wall thickness of 3mm. The
software analysed the file and found it to be good.
However, when i sent the file to Lightyear to verify the same file, it said
that the file was bad and repaired the file accordingly. When i checked the
verified file in Magics again, it was a solid! How do i analyse parts in
Lightyear that have been hollowed by another software?
Any workarounds?
This is a great mailing list!!
Best regards,
Raymond Tan,
Rapid Prototyping and Manufacturing Center,
Research & Development Department,
PROTON BHD.
Shah Alam,
40918, Selangor,
MALAYSIA.
Ph: 603-5111055 ext. 2542
Fax: 603-5152380
http://www.proton.com/rapid/main.htm
============================================================
Disclaimer Note:
"This email and any files transmitted with it are confidential and intended
solely for the use of the individual or entity to whom they are addressed.
This communication may contain material protected by intellectual property
rights laws. If you are not the intended recipient or the person responsible
for delivering the email to the intended recipient, be advised that you have
received this email in error and that any use, dissemination, forwarding,
printing, or copying of this email is strictly prohibited. If you have
received this email in error please notify the System Administrator at
administrator@proton.com.my "
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:52:55 EEST