Dear list,
I am searching for some information on cooling channels in direct AIM tools:
1) Can I use water cooling or is the humidity resistans of the
stereolithograpy tool to poor?
2) Do I need to use a special resin with better humidity resistans like 5530
from Ciba?
3) Has anybody done calculations on how close to the part cooling channels
can be situated without damaging the mould with a certain injection
pressure?
Regards
Tine
Tine Hejslet Jørgensen
Danish Technological Institute
Teknologiparken
Kongsvang Allé 29
8000 Aarhus C
Denmark
Tel: +45 8943 8704
Fax: +45 8943 8425
Email: tine.jorgensen@teknologisk.dk
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:53:15 EEST