Dear List
Does anyone know of a CAD system which can given a start geometry and an end geometry interpolate between the two say in steps of X outputting a CAD geometry at each step.
To illustrate further consider the following geometries
Start Geometry cylinder 10mm dia end cylinder 100 mm geometry step 9. The output would be 9 (or is it 10?) cylinders at 10mm diameter increments all on the same centres
The software I need would have to do this on more complex free form geometries.
Many thanks in advance for the replies.
Chris
Dr. Chris. Sutcliffe
Rapid Prototyping and Micromanufacture Research
Product Innovation and Development Centre
Department of Engineering
3 Brownlow St.
Liverpool L69 3GL
(0151) 794 8022 Direct
(0151) 794 7729 Mobile
(0151) 794 8021 Secretary
EMail c.j.sutcliffe@liv.ac.uk
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:53:17 EEST