It depends on the setting of your build parameters. Based on the default
setting from 3D Systems, you can only build 0.15mm. But if you adjust the
build parameters, it is possible to build 0.10mm. Give a try.
"Bess Macier" <bmacier@andisco.com> wrote:
Hello,
Can anyone tell me what the smallest build size per layer would be if you were
using 250 SLA machine?
Thanks in advance to all replies.
Bess Macier
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
Spencer .O. Onuh (Ph.D)
Department of Engineering
University of Wales College, Newport
Allt-yr-yn Campus
P.O. Box 180
Newport. NP9 5XR
United Kingdom
____________________________________________________________________
Get free email and a permanent address at http://www.netaddress.com/?N=1
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 23:02:51 EEST